Idiomas disponibles
Idiomas disponibles
1.
Description of a Lyra transmitter
Transmitter specifications
Battery
Operating time
IP Protection rating
Used frequency band
Maximum power
Key block
In Pulse mode, the function keys ▲&▼ cannot be used simultaneously.
Replacing the battery of the Lyra transmitter
Loosen the screws on the back of the transmitter and carefully open the casing.
Replace the battery (9V block battery) and close the casing.
System configuration
The Lyra/Hydrus system has 2 different configurations one of these can be selected during programming.
•
Pulse mode, pressing = ON, releasing = OFF.
•
Latching mode, press key and releasing = ON, again pressing key and releasing = OFF.
At the factory, the system is configured in Pulse mode. If you wish to change this see chapter 6.
2.
Range optimisation
The location of the receiver is of great influence on the maximum range, therefore, please take into account the following points in order
to optimise the range of the system;
•
Place several receivers at least 50cm apart.
•
Never directly place the receiver or antenna on metal objects but at least 50 cm away
•
Mount the receiver or antenna approximately 3 to 4 metres above work height, higher or under work height reduces range
significantly
•
Place the receiver or antenna at least 50 cm away from engines or other devices that can generate a force field
•
Never place the receiver with antenna in the cabin of a vehicle, a switchbox, or a similar (metal) casing
•
If possible try to maintain a line of sight with the receiver during operation
•
Applications like axle steering or winching where the work height is equal, the aerial has to be mounted vertical
•
Applications like hoists where the working height greatly differs, the aerial has to be mounted horizontal
Range
The maximum range indicated is based on a measurement with the line of sight without interference.
The indicated range cannot be guaranteed because it is always subjective to variable environmental factors.
In particular deflection, reflection and shadows can decrease the maximum range.
Objects present in between the transmitter and the receiver, in particular metals, reinforced concrete or absorbing objects like trees or
snow, have an unpredictable influence on the maximum range.
In general the optimal range can be achieved when there is a line of sight between the transmitter and the receiver.
Frequencies
Check if there are no other wireless devices that operate on the same frequency as those will, this will have a negative impact on the
performance and the range of the system.
Manufacturer: Tyro Remotes
Bedrijvenpark Twente 299
7602 KK, Almelo - The Netherlands
1.
Transmission indicator (green LED)
•
LED flashes for each signal transmitted.
•
When the battery is almost empty, the LED flashes more
slowly.
2.
Battery indicator (red LED)
•
This LED flashes when the battery is almost empty.
3.
Function keys
•
These keys control the functions of the system
•
Can be executed as pulse or latching (key hold-down function)
4.
ON-button
•
Press down for 2 seconds, to activate the transmitter and the
receiver.
5.
OFF-button
•
Immediately switches off the transmitter and the receiver.
1x 9V block 600 mAh
Approx 2 years
IP65
868 MHz
10 dBm
Publisher:
Tyro Remotes
Version:
Date:
9
Page
9
