Adler europe AD 7751 Manual De Uso página 12

Note: If the power cord or power plug is damaged, it should always be replaced or
repaired by a specialized repair shop.
II. WARNINGS
1. Never use the device if it is damaged or does not function properly.
2. Never use the device if it has fallen from a height before and shows visible signs of
damage.
3. Do not use extension cords or other electrical outlets that do not meet the applicable
standards and electrical regulations.
4. Any repairs, dismantling or replacement of any parts should always be made by a
specialized facility.
5. If the device and elements such as electrical contacts are wet, the plug or cable should
be dried before using the device and its components.
6. Do not use the device with wet hands.
7. When there is a risk that the device has been damaged NEVER try to repair the device
yourself.
8. Never wash the device under running water or in such a way that water drips into it.
9. Do not use accessories that are not recommended by the manufacturer. They may
pose a danger to the user and may cause damage to the device.
10. Ensure that the device has cooled down before storing.
11. Do not touch the housing during use. During operation, use only knobs and switches.
After switching off, wait for the device to cool down.
12. CAUTION: Some parts of this device may become very hot during operation and
cause burns.
Description of device: air curtain ceramic heater AD7751 – look at Figure 1
1.Main power switch
3.Front cover
5.Air outlet
7.Remote control
9.Wall pegs
Description of buttons and indicators – look at Figure 2
A. Power button
B1.Open window mode indicator
F.Fan mode selection button
one the Sun icon
F2.High heating level mode 2000W indicator – two the Sun icons
G1.Timer indicator indicator
J."SET" button
L.Minus button
P.Weekly programme button
S."Edit" button
W. "Time/OFF" button
III. Function operation (touch display – manual operation)
1.Plug in and switch on the device by pressing the main power switch (1). Position O – means switch off. Position I means switch on.
After switch on, the device enters into standby mode and digital display (H) shows letter S – look at Figure 3.
2. To set up fan mode:
2.Power cord
4.Display panel
6.Base
8.Wall mounting screw
B.Open window mode button
E.Temperature setting indicator
F1.Low heating level mode 1000W indicator–
G.Timer button
H. Digital display
K.Plus button
M.Confirmation button "OK"
R."Day" button
U. "Time/ON" button
12