Idiomas disponibles
Idiomas disponibles
1. If a nozzle is installed on the spray lance, remove it
from the spray lance. Refer to
370) on page 22 .
2. Clean the nozzles, the coupling on the spray lance,
and the coupling on the spray handle with soap and
water. (Fig. 67)
3. If there is blockage in the nozzles, remove it with the
cleaning tool. (Fig. 68)
To clean the water filter
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source before you do maintenance
on the product.
1. If the garden hose adapter is installed, remove it
from the water inlet on the product. (Fig. 48)
2. Pull out the water filter. Use a pair of pliers. (Fig. 69)
3. Do a check for damage on the water filter. Replace
the water filter if it is damaged. (Fig. 70)
4. Flush the water filter with clean water. (Fig. 71)
5. Install the water filter in the opposite sequence.
To clean the filter in the foam sprayer
1. Carefully push out the pin a small distance with a
small hex key or equivalent tool. (Fig. 72)
2. Pull out the pin with a pair of pliers. (Fig. 73)
3. Turn the nozzle cover counterclockwise and remove
it from the foam sprayer. (Fig. 74)
4. Remove the ring. (Fig. 75)
5. Remove the screw and the cover on the right side.
(Fig. 76)
6. Remove the screw and the cover on the left side.
(Fig. 77)
7. Remove the clip and the nozzle assembly. (Fig. 78)
8. Pull out the filter holder (A) with a pair of pliers. (Fig.
79)
9. Carefully push out the filter (B) with a small hex key
or equivalent tool.
26
Nozzles (PW 360, PW
Put the power switch in the
Disconnect the product from
10. Flush the filter with clean water. Replace the filter if it
is damaged or cannot be fully cleaned. (Fig. 80)
11. Assemble the foam sprayer in the opposite
sequence.
To lubricate the O-rings on the
couplings
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
1. Remove the spray lance from the spray handle and
the spray handle from the high-pressure hose. Refer
to
To remove the spray lance on page 21 and To
install the spray handle on page 21 .
2. Lubricate the O-rings on the garden hose adapter,
the spray lance, and the high-pressure hose with
Technical data on page 29 for the
grease. Refer to
correct type of grease. (Fig. 81)
To remove and install the hose reel
cover
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
The hose reel cover is attached with 3 snap locks.
1. Push in the 3 snap locks and carefully remove the
hose reel cover. (Fig. 82)
2. To install the hose reel cover, carefully push it until
the snap locks locks it in position.
Put the power switch in the
Disconnect the product from
Put the power switch in the
Disconnect the product from
2167 - 004 - 18.12.2023
