Schluter Systems DH E RT2 / BW Manual De Instrucciones página 8

Cautions
This instruction must be observed, otherwise the liability
of the manufacturer shall be voided.
Any changes or modifications made to this
thermostat shall void the liability of the manufacturer.
Maximum product lifetime is achieved if the product is not
turned off but set at the lowest possible set point / frost
protection when heat is not required.
Notice
The language used in the original documentation is
English.
Other language versions are a translation of the
original documentation.
The manufacturer cannot be held liable for any errors in the
documentation. The manufacturer reserves the right to make
alterations without prior notice.
Content may vary due to alternative software and/or
configurations.
Fig. 3 - Thermostat placement
Mounting of sensor
Although two sensors are supplied and both should be
installed only one sensor should be connected to terminals 5
and 6 in the thermostat. The unconnected sensor should be
regarded as a 'spare' and only connected in the event of the
other sensor being damaged and/or failing.
The floor sensor contains a safety extra-low voltage (SELV)
circuit, allowing it to be placed as close to the floor surface as
possible without having to take account of the risk of shock
should the sensor cable become damaged. The two wires
connecting the sensor to the mounting box must be additio-
nally insulated, e.g. shrink flex.
To prevent loose wires in the fixed installation from coming
into contact with the terminal block for the floor sensor, they
must be restrained using cable ties.
It is strongly recommended that the cable and sensor are
placed in a non-conductive installation pipe embedded in
the floor. The end of the pipe must be sealed and the pipe
8
© 2022. All rights reserved. Used under license by Schlüter-Systems KG
English