Sanding Pad Brake; Accessories - Festool ROTEX RO 90 DX FEQ Manual De Instrucciones

Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festoolusa.com/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
Check all warnings on the electric power tool
for readability and completeness. Replace
missing or illegible warnings.

10.1 Sanding pad brake

The rubber collar [10-1] on the sanding pad
and the stop ring [10-2] on the machine prevent
uncontrolled excessive turning of the sanding
pad during eccentric motion (fine sanding). As
these parts are subject to wear in the course of
time, they must be replaced when reduced
braking force is observed (for order no., see
spare parts list).
3

11 Accessories

Use only original Festool accessories and
Festool consumable material intended for this
machine. These components are designed spe­
cifically for this machine. Using accessories
and consumable material from other suppliers
will most likely affect the quality of your results
and limit warranty claims. Machine wear or
your own personal workload may increase de­
pending on the application. Protect yourself and
your machine, and preserve your warranty
claims by always using original Festool acces­
sories and Festool consumable material!
Only use original Festool sanding and polishing
pads. Low-quality sanding and polishing pads
may cause serious machine imbalance that de­
creases the quality of the working results and
increases machine wear.
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under "www.festoolusa.com".
11.1 SYSTAINER
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro­
vides protection and storage for the tool and ac­
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
Turn the T-loc [SYS-b-1] to this posi­
tion.
To lock the Systainer
Turn the T-loc [SYS-b-1] to this posi­
tion.
To connect two Systainers
Place one Systainer on the top of the other
(Fig. [SYS-a]).
Turn the T-loc [SYS-b-1] to one of
this positions (Fig. [SYS-b]).
The Systainers are connected and locked.
A new generation Systainer is con­
nectable on top of a previous genera­
tion Systainer by the four latches of
the previous Systainer.
English
15