ENGLISH
models. Fig. 13
-
Locate the light connection cable terminal and remove it. Fig. 14
Way 1. Use a tool or your hand to press the spring splinter on both sides of the LED light
inwards, until the light is pressed out. Then, pull the light connection cable slightly outwards.
Way 2. Use a straight screwdriver to lift up the bottom edge of the LED light, then pull the
light's connection cable slightly.
-
Apply the reverse procedure to install the rear lamp.
-
The ILCOS D code for this light is: DBS-2/65-H-120/33
-
LED modules - rectangular lamp
-
Maximum power: 1 x 2 W
-
Rated voltage: AC 110-240 V
4. CLEANING AND MAINTENANCE
Warning:
-
Before carrying out any maintenance or cleaning operations, disconnect the kitchen hood
from the mains power supply. Make sure that the kitchen hood is disconnected from the
mains and that the mains plug has been removed.
-
The exterior surfaces are susceptible to scratches and abrasions, so please follow the
cleaning instructions to achieve the best possible result without damaging them.
General
Cleaning and maintenance must be carried out when the appliance is cold. Avoid leaving
alkaline or acidic substances (lemon juice, vinegar, etc.) on surfaces.
Stainless steel
Stainless steel must be cleaned regularly (e.g., weekly) to ensure a long service life. A
specialised cleaning fluid for stainless steel can be used.
NOTE:
Be sure to clean following the grain of the stainless steel to avoid unsightly crosshatching.
Control panel surface
The embedded control panel can be cleaned with warm soapy water. Make sure the cloth is
clean and well wrung out before wiping. Use a soft, dry cloth to remove any excess moisture
that may remain after cleaning.
Important
Use neutral detergents and avoid the use of harsh cleaning chemicals, strong household
detergents or products containing abrasives, as this will affect the appearance of
the appliance and potentially remove any artwork on the control panel and void the
manufacturer's warranty.
60
FLUX PM 604300 INOX C / FLUX PM 604300 BLACK C