Idiomas disponibles
Idiomas disponibles
Procedure
6. Install By-pass
Use of an external 3-valve by-pass or equivalent is
recommended.
8. Set Meter Disc
Set number of gallons between regenerations based on your system size and inlet water quality (see step 10).
Remove cap
screws
Insert new meter disc
Remove cap and
actuator
Gently turn disc clockwise
until pawls fall in place
7. Connect Softener
Connect softener to main plumbing via by-pass.
Connect softener to main plumbing via by-pass.
Do not solder brass adapters while they are inserted in
the control module.
Take care during the installation process to assure that
solder and flux do not come in contact with:
media tanks
control module
E-clips
related plastic components
Remove existing use
meter disc
Replace actuator and
cap
4
Make sure pawls are
back before inserting
new meter disc
3
6
7
2
8
1
4
5
Tighten cap screws (8)
in order shown
