Idiomas disponibles
Idiomas disponibles
KRS-01
MAX Hold button
To hold the highest reading on the LCD
•Press the MAX hold button. The meter reading will not change as readings change
•Press the MAX hold button again to return to normal operation.
Hold Button
The Data Hold function allows the meter to "freeze" a measurement for later reference
•Press the "DATA HOLD" button to "freeze" the display, the "HOLD" indicator will appear.
•Press the "DATA HOLD" button to return to normal operation.
Auto Power Off
The auto off feature will turn the meter off after 15 minutes.
Replacing The Fuses
• Disconnect the test leads from the meter.
• Remove the protective rubber holster.
• Remove the battery cover (two "B" screws) and the battery.
• Remove the four "A" screws securing the rear cover.
• Lift the center circuit board straight up from the connectors to gain access to the fuse
holders.
• Gently remove the old fuse and install the new fuse into the holder.
• Always use a fuse of the proper size and value (0.2A/250V fast blow for the 200mA range).
• Align the center board with the connectors and gently press into place.
• Replace and secure the rear cover, battery and battery cover.
Warning: To avoid electric shock, disconnect the test leads from any source of voltage
before removing the fuse cover.
6. Accessories
• User manual.
• 3V(1.5V AAA*2) battery and 9V type batery.
• Carrying case.
8
EN
EN
7. Safety and maintenance
• Operating altitude: below 2000m.
• Operating environment: for indoor use, expose to pollution level II.
• This is a precisi0n device: Dring use or storage, do not go beyond its spec. to prevent
any possible damage or danger.
• Do not put this device in direct sunlight or where it is hot an or damp.
• Remember to turn OFF the power after use. For long storage. Remove the battery to
prevent the battery from leaking to cause damage to the parts inside.
• Clean the device with a dry soft cloth. Wet cloths, liquid and water are prohibited.
8. Battery Replacement
• When the symbol " " is display, batteries need replacement. Turn off the meter and
disconnect the test leads from the input terminals.
• Unscrew the battery cover and remove the battery. Insert a new battery of the same
type (1.5V AAA*2 battery or 9V type batery).
observing the proper polarty, re-screw the battery cover and reposition the protective
holster.
KRS-01
9
