cecotec CAFELIZZIA FAST PRO Manual De Instrucciones página 42

ENGLISH
Restore factory settings
If you want to restore factory settings, hold pressed at the same time the 1-coffee button and
the steam button for 3 seconds. The appliance will beep indicating factory settings have been
successfully restored.
Cooling function of the machine
- After producing steam, the temperature of the coffee machine is likely to increase
significantly. In fact, when the steam button is turned off, the indicator lights will start
flashing indicating that the temperature of the machine is too high, so it will be necessary
to cool down the machine if you want to brew coffee.
- To allow the machine to cool down, turn the steam knob to the water position so that
the machine dispenses water for a few seconds. Then, turn the steam knob to the off
position. The cooling function of the machine will have finished when the indicator lights
stop flashing. When the indicator lights remain steady, the machine is ready for use.
4. CLEANING AND MAINTENANCE
- Disconnect the appliance from the power supply and allow it to cool down completely
before cleaning.
- Do not use abrasive cleaners or scouring pads, as they could cause damage to the
appliance's surface.
- Use a soft, dampened cloth to clean the outer part of the appliance.
- Do not immerse the main body in water or other liquids.
- Wash the water tank, drip tray and cup holder tray regularly.
- After using the steam function, the tube must be cleaned with a cloth immediately after.
- Allow steam to be released to avoid possible blockages inside the tube.
- If the steam tube is clogged, use a needle to unblock the conduct.
- Remove the portafilter and empty all coffee residues inside it. Then, use water and a
cloth to clean it. Do not wash it in the dishwasher.
- Clean all parts with water and dry thoroughly before storing it or using the appliance
again.
Descaling
When the device has been used 500 times, either for steaming or for coffee brewing, it is
recommended to carry out a descaling cycle.
1. Fill the water tank with water up to the MAX. level and add about 10 g of descaler.
Switch on the coffee machine and allow it to heat up. Once the preheating process is
2.
finished, turn the steam knob to the water position and turn it back to the off position
from time to time to dispense water little by little. The machine will stop operating after
2 minutes.
42