Idiomas disponibles
Idiomas disponibles
GB
Clean cleaning foot (see Fig. N)
1.
Press the release and remove the brush roll cover.
2.
Grasp the brush roll on the left and remove it upwards.
3.
Remove any hairs, threads or similar from the roll.
4.
Remove dirt from the intake duct with a damp cloth. Do not hold the cleaning foot under running water to avoid
damaging the electrical connections.
5.
Clean the brush roll and the cover under running water.
6.
Allow all parts to dry fully.
7.
Put back the brush roll.
8.
Put on the brush roll cover and snap it into place.
Troubleshooting
Only for electrical appliances
WARNING!
Switch off the appliance and disconnect the mains plug before addressing any faults! Failure to do so may result in
injury or electric shock.
Problem
Appliance isn't working Battery is empty
Battery will not charge Appliance is not correctly
Suction power
decreases
Noise from the suction
opening
30
Instruction manual
Possible causes
Brush roller is blocked
Waste water tank is full
Suction opening is blocked
Water tanks, brush roll, or brush
roll cover not correctly /
completely inserted
Appliance is in the upright
position
connected to a power socket
Suction opening is blocked
Filters are blocked
Waste water tank is contamina-
ted
Brush roller is blocked
Suction opening is blocked
Solution
Charge the battery
Clean the brush roller and remove debris such as hair
and fibres if necessary
Empty the waste water tank
Clean the suction opening
Check the correct fit of all parts and remove blockages /
dirt if necessary
Hold the floor brush with your foot and move the
appliance by the handle to a diagonal position
Press the On/Off switch again
Connect the mains supply unit correctly to a functio-
ning power socket
Clean the suction opening and check the suction tube
for any dirt
Clean the sponge filter, mesh filter and filter unit
Clean the waste water tank
Clean the brush roller and remove debris such as hair
and fibres if necessary
Clean the suction opening and remove the residues
