Idiomas disponibles
Idiomas disponibles
HOSE CHECK
Before each use, check to see if hoses are cut or worn. Replace damaged hose assembly before using appliance. Use
only valve/hose/regulator specified by manufacturer.
Do not attempt to adjust the burner. It is preset to the factory specifications.
THERMOMETER TEST
Always use a thermometer when frying any food. A thermometer is a sensitive measuring device which may not
work properly if dropped, bent, or twisted. Always check to be sure your thermometer is working properly
before frying. DO NOT use a meat thermometer for frying.
TEMPERATURE ACCURACY TEST
While wearing protective gloves, hold the thermometer by the dial and insert the stem into boiling water. The needle
should quickly move around the dial and register approximately 212°F (100°C) (plus or minus 5°F). This indicates whether
or not the temperature reading is accurate.
NOTE: Due to water evaporation, the maximum reading possible on a thermometer in hot water is 212°F (100°C).
TEMPERATURE RANGE TEST
Hold the thermometer by the dial and place the end of the stem above a lit match or lighter. The needle should quickly
move around the dial and register a temperature reading far above 350°F(177°C). If the needle stops at a low tempera-
ture reading such as 225°F(107°C), then the thermometer is damaged and cannot be used.
NOTE: DO NOT attempt frying if the thermometer is not working! If the thermometer supplied with this fryer or boiler
has been lost or damaged, a replacement thermometer must be one specified by the appliance manufacturer.
WARNING
WARNING
6
INSTRUCTIONS FOR LIGHTING BURNER
WARNING: BEFORE LIGHTING
1. Read the instructions before lighting.
2. If the burner does not ignite in 5 seconds, turn the regulator valve off, wait 5 minutes and repeat the lighting
procedure.
3. Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear, or abrasion, it must
be replaced prior to use. Do not use the appliance if the odor of gas is present. Only use the pressure regulator
and hose assembly supplied with the unit.
4. Never use regulators and hose assemblies other than those supplied with the appliance. If a replacement is
necessary, contact the manufacturer to get the proper replacement. The replacement must be as per the specifi-
cations in the Owner's Manual.
DO NOT LEAVE THE APPLIANCE UNATTENDED WHILE COOKING.
LIGHTING BURNER USING ELECTRONIC IGNITION
1.Ensure the regulator valve is completely closed.
2.Open gas cylinder valve by turning counterclockwise.
3.Open the regulator valve by turning clockwise.
4.Push and hold ignitor button to light the burner.
5.If the burner does not ignite, turn off the regulator and cylinder valve, wait for 5 minutes before attempting to relight the
burner.
6.If the burner ignites, turn the regulator valve to the desired heat setting.
* Should the burner still fail to ignite, check the gas supply.
LIGHTING BURNER USING IGNITOR OR MATCH
Do not lean over LP cooker while lighting. Read all instructions before lighting and only light burner outdoors.
1.Remove all appliances from the burner to create a free flow of air.
2.Turn control valve(s) to OFF position.
3.Slowly open LP bottle valve.
4.Light a long match (fireplace match) and place it over burner. If using a short match, place the unlit match into the match
holder then light the match. Slowly rotate the the regulator control knob until burner is lit.
5.If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedure.
BURNER FLAME CHECK
Light the burner and adjust the flame with the regulator control
valve until the desired flame is achieved. Always check the flame
prior to each use. A blue flame with little or no yellow flame
provides the best heat.
Good
Bad
Yellow
Yellow
Light Blue
Light Blue
Blue
Blue
7
