Idiomas disponibles
Idiomas disponibles
545150008
OPERATION AND STORAGE
TURNING THE PATIO HEATER ON
1. Turn the valve on the gas bottle to open.
2. Push the control button in and turn to PILOT setting. Keep the button depressed for at least
60 seconds (around 1.5 minutes if you have attached a new gas bottle).
3. While pressing the control button, press a couple of times on the ignition until the pilot light
goes on. Keep the control button depressed for another 30 seconds in order to activate the
thermocouple. You can now release the control button.
4. Turn the control button to the lowest setting and leave the patio heater to burn for five
minutes. You can then turn the control button to the desired setting: Hi = maximum.
5. The pilot light can be viewed and checked via the peephole with the slider which can be found
on the side of the flame screen.
TURNING THE PATIO HEATER OFF
1. Turn the control button to PILOT setting.
2. Press the control button in and turn to OFF.
3. Close the regulator on the gas bottle completely
STORAGE
Check that the regulator on the gas bottle is closed properly.
•
Remove the gas regulator and the gas bottle hose.
•
Check the gas bottle for damage and the regulator for a perfect connection. If you notice
•
damage or any other issues, change the gas bottle with your gas supplier.
Always store gas bottles in an area with good ventilation.
•
Store the patio heater, without gas bottle, in a dry, dust-free and safe area. If necessary as a
•
result of a lack of storage height, you can remove the burner and reflector cap and store these
separately. If possible, use the original packaging materials to protect the device during
storage!
Always store the patio heater clean and ensure that it is dust and dirt free when you wish to
•
use it again.
EN
16
