Tabla de contenido
Idiomas disponibles
Idiomas disponibles
After using the mist blower equipped with the pump, it is important to clean both
the liquid tank (The User manual of the Mist blower MB90 / AT900) and the
pump.
W
ARNING
tank and in the circuit of the pump for several days
W
ARNING
flows.
C
l
C
l
To clean the filling pump:
Make the filling operations as described at page 7, using at least 5 or 6 liters of
clean water.
Let the water flows by opening the tap (see user manual of the Mist blower
MB90 / AT900 Chapter " Liquid flow regulator") and by placing the locking button of
the faucet, located on the handle, in the maximum opening position (see
instructions on the User Manual of the Mist blower MB90 / AT900).
C
l
e
C
l
e
To clean the booster pump, proceed as follows:
Check that the liquid faucet (User manual of the Mist blower MB90 / AT900) is
closed.
Pour about 5 or 6 liters of water into the tank (you can also use the booster
pump if your mist blower is equipped with)
Start the engine.
In case your mist blower is a model MB90 / AT900 (that is, equipped
with a booster and filling pump), check that the switch lever (Figure 7 position
1) is in position PS.
Accelerate about halfway through and run the engine for about one minute.
Turn off the engine.
Let the water flows by opening the faucet (User manual of the Mist blower
MB90 / AT900, Chapter "Liquid flow regulator") and by placing the locking
button of the faucet, located on the handle, in the maximum opening
position (see User Manual of the Mistblower MB90 / AT900, Chapter " Handle
commands").
M
AINTENANCE OF THE PUMP
: Absolutely avoid that the chemical solution persists in the liquid
: The tank is filled with chemicals. Pay attention where the water
e
a
n
i
n
g
o
e
a
n
i
n
g
o
a
n
i
n
g
o
f
a
n
i
n
g
o
f
f
t
h
e
f
i
l
l
f
t
h
e
f
i
l
l
t
h
e
b
o
o
s
t
h
e
b
o
o
s
19
i
n
g
p
u
m
p
i
n
g
p
u
m
p
t
e
r
p
u
m
p
t
e
r
p
u
m
p
Pump PSR
Capítulos
Tabla de contenido
