Idiomas disponibles
Idiomas disponibles
use in pressure washers and specific cleaning tasks. The use of thick soaps, like the soap used
with tableware, can clog the injection system with chemical products.
Note
Soaps work better when applying them on spray mode.
The chemical action combined with high-pressure rinses in concentrated mode is very effective.
In vertical surfaces, apply soap from bottom to top. This will prevent soap from dripping down
and creating stains. High-pressure rinses can also be carried out from bottom to top. With
stains particularly difficult to remove you may need to use a brush along with soap and high-
pressure rinses. Follow the instructions in the next section to use this accessory. Fig. 6
Anti-impurities filter
This model includes a transparent male connector with a filter that can be assembled with
the hose to prevent the dust from getting through. This accessory is inserted into the water
outlet (6).
Cleaning process
The following cleaning procedure will help you organise and ensure you get the best results.
Remember to follow the previous advice.
Preparing the surface
-
Clear the area of furniture and check that windows and doors are securely closed.
-
Also make sure that plants and trees near the area to be cleaned are protected with a cloth.
Initial high-pressure rinse
Spray the area to be cleaned with water to clean any dirt that may have accumulated on
the surface. Before pressing the trigger, move the spray nozzle to the spray mode position
and progressively move it to the desired spray position. This way, you will avoid applying an
excessively direct jet on more delicate surfaces.
Use of soap
Water and soap must be used in a 1:19 ratio: 5.4% soap, 94.6% water.
Warning
Use only soaps designed for pressure washers.
-
Test the soap in an inconspicuous place before using the product.
-
Loosen the cap of the soap bottle and fill it with water and soap.
-
Replace the cover.
-
Disassemble the lance from the trigger gun.
HY D ROB OOST 14 00 ES SEN TI A L
ENGLISH
67
