Idiomas disponibles
Idiomas disponibles
Mesh primary filter and sponge filter
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendations
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot motor and damage it.
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
robot lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the multifunctional brush
1. Slightly press the multifunctional brush's frame tabs to open the slot and remove it. Fig. 31
2. Remove any hair, lint, or other dirt trapped in the brush and around the shafts.
3. Clear and clean the robot vacuum cleaner's suction channel. Fig. 32
4. Reinstall the multifunctional brush and its frame.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to clean thoroughly edges and corners. These brushes can wear out over time,
negatively affecting cleaning efficiency. For this reason, it is suggested to replace each side
brush after a maximum of 220 hours or less.
Recommendations:
It is recommended to clean the side brushes once a week with the help of the cleaning brush.
Sensors
-
Your robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles, or free-fall sensors that
help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
-
It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
35 hours of operation or less.
ENGLISH
47
