Idiomas disponibles
Idiomas disponibles
-
Direct exposure to sunlight or great light contrasts may affect to the correct operation of
the sensors. If this happens, the robot will stop operating. Move it to a new location for it
to start operating again.
3. INSTALLATION
1. Place the charging base against the wall and leave a minimum free space of 2 metres to
the front and 1 metre to each side. Fig. 15
2. Connect the charging base to a power socket. Wind and store the remaining cable in the
lower part of the charging base to prevent accidents. Fig. 16
3. Install both side brushes in their corresponding slots, located on the robot lower part.
Press until it clicks to make sure they are properly fixed. Fig. 17
4. Press the power switch located on the lower part of the robot. Make sure the power switch
is in the on position (I). Fig. 18
5. Place the robot on the charging base and make sure the charging terminals on the robot
match those of the charging base. Once the robot is properly placed, it will beep once,
and the light indicator will light up. If the light blinks orange, it means the battery is not
completely charged. To ensure the maximum cleaning time, wait until the light turns into
steady blue, as this will indicate the battery is fully charged and the robot is ready to clean.
Fig. 19
4. OPERATION
Cleaning
start Fig.
20
-
Hold down the Start/Pause button on the robot to turn it on.
-
Press the Start/Pause button on the robot vacuum cleaner or on the remote control to
start cleaning.
Note:
-
If the robot runs out of battery while cleaning, it will automatically return to the charging
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
-
If there is no good access to the charging base, the robot will not be able to return to it. If
this happens, place it manually on the charging base.
Pausing the cleaning. Fig.
-
Press the Start/Pause button on the robot vacuum cleaner or on the remote control to
pause the cleaning process.
-
Press the Start/Pause button on the robot vacuum cleaner or on the remote control to
resume the cleaning process.
20
ENGLISH
43
