8. Replacement of Poly-V-Belt
Poly-V-belt
Pulley (B)
Fig. 49
9. Lubrication
Lubricate the following sliding surfaces once a month to keep the power tool in good operating condition for a
long time (see Fig. 1 and Fig. 2). Use of machine oil is recommended.
Oil supply points:
* Rotary portion of hinge
* Rotary portion of vise assembly
10. Cleaning
Duct
Air gun
Fig. 50
CAUTION:
In the operation and maintenance of power tools, the safety regulations and
standards prescribed in each country must be observed.
SERVICE AND REPAIRS
All quality power tools will eventually require servicing or replacement of parts because of wear from normal use. To
assure that only authorized replacement parts will be used and that the double insulation system will be protected,
all service (other than routine maintenance) must be performed by an AUTHORIZED metabo HPT POWER TOOL
REPAIR CENTER ONLY.
NOTE:
Specifi cations are subject to change without any obligation on the part of metabo HPT.
The power of the motor is transmitted to the saw blade by a Poly-V-Belt.
When the Poly-V-Belt is broken or damaged, remove the pulley cover by
loosening the three 5 mm screws (see Fig. 2) and replace the damaged
Pulley (A)
one with the new one.
When connecting the belt on pulleys, fi rst connect 2 or 3 teeth of Poly-V-
Belt to the grooves of the pulley (A) and pulley (B). Then turning the pulley
(A) and pulley (B), connect all teeth of the belt to the pulleys.
Lower Guard
Clean the machine, duct and lower guard by blowing with
dry air from an air gun or other tool.
Periodically remove chips, dust and other waste material
from the surface of the power tool, especially from the
inside of the lower guard with a damp, soapy cloth. To avoid
a malfunction of the motor, protect it from contact with oil or
water.
If the laser line becomes invisible due to chips and the like
adhered onto the window of the laser marker's light-emitting
section, wipe and clean the window with a dry cloth or a soft
cloth moistened with soapy water, etc.
English
25