Metabo HPT C 12LDH Manual De Instrucciones página 21

Cutting method of crown molding without tilting the saw blade
6mm wing
Crown molding
bolt
vise ass'y
(Optional
accessories)
6mm
wing
bolt
6mm wing Crown molding stopper (L)
bolt (Optional accessories)
Fig. 41-a
Crown molding vise ass'y
(Optional accessories)
6mm knob bolt
Fence
Crown molding
6mm wing bolt
Fig. 41-b
WARNING:
Always fi rmly clamp or vise to secure the crown molding to the fence; otherwise the
crown molding might be thrust from the table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the sub fence,
resulting in an injury.
CAUTION:
Always confi rm that the motor head (see Fig. 1) does not contact the crown molding
vise ass'y when it is lowered for cutting. If there is any danger that it may do so,
loosen the 6mm knob bolt and move the crown molding vise ass'y to a position
where it will not contact the saw blade.
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT
EDGE against the crown molding Stoppers as shown in Fig. 41-b.
Adjust the crown molding Stoppers according to the size of the crown molding.
Tighten the 6mm wing bolt to secure the crown molding Stoppers.
9. Cutting easily-deformed materials, such as aluminum sash
Materials such as aluminum sash can easily deform when tightened too much in a vise assembly. This will
cause ineffi cient cutting and possible overload of the motor.
When cutting such materials, use a wood plate to protect the workpiece as shown in Fig. 42-a. Set the wood
plate near the cutting section.
When cutting aluminum materials, coat the saw blade with cutting oil (non-combustible) to achieve smooth
cutting and a fi ne fi nish.
In addition, in case of a U-shaped workpiece, use the wood plate as shown in Fig. 42-b to ensure stability in
the lateral direction, and clamp it near the cutting section of the workpiece and tighten it using both the vise
assembly and the clamp available in the market.
Fence
6mm knob bolt
(1) Crown molding Stopper (L) and (R) (optional accessories) allow
Crown molding
easier cuts of crown molding without tilting the saw blade. Install
stopper (R)
(Optional them in the base both-sides side to be shown in Fig. 41-a. After
accessories)
inserting Tighten the 6mm wing bolts to secure the crown molding
Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include Crown molding Stopper (L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
(2) The crown molding vise (B) (Optional accessory) can be mounted on
either the left fence (Fence (B)) or the right fence (Fence (A)). It can unite
with the slope of the crown molding and vice can be pressed down.
Then turn the upper knob, as necessary, to securely attach the
Knob
crown molding in position. To raise or lower the vise assembly, fi rst
loosen the 6mm knob bolt.
After adjusting the height, fi rmly tighten the 6mm wing bolt; then turn
the upper knob, as necessary, to securely attach the crown molding
in position. (See Fig. 41-b)
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
Vise
assembly
Wood
plate
Aluminum
sash
Wood plate
Fig. 42-a
Vise assembly
Clamp
Fence
Wood plate
Wood plate
Aluminum sash
Fig. 42-b
English
21