Idiomas disponibles
Idiomas disponibles
−
Battery cartridge replacing signal
−
When the remaining battery capacity gets
small, the indicator lamp lights up during
operation earlier than enough capacity
battery use.
−
Accidental re-start preventive function
−
Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)"
position, the tool does not start. At this time,
the lamp flickers slowly and this shows that
the accidental re-start preventive function is
at work.
−
To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide
it toward the "I (ON)" position.
Adjusting the depth of groove
3
2
012682
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence
between the sizes marked on the stopper and the biscuit
size. Fine adjustments to the grooving depth can be
made by turning the adjusting screw after loosening the
hex nut. This may become necessary after the blade has
been resharpened a few times.
Size on stopper
0
Biscuit size
0
8 mm
10 mm
Depth of groove
(0.3")
(0.4")
* With the rubber spikes removed.
012683
Angle guide
The angle guide height can be moved up and down to
adjust the position of the blade in relation to the top of
the workpiece.
1
5
6
7
2
3
012497
1. Pointer
2. Stopper
1
3. Adjusting screw
4. Rubber spike
4
10
20
S
D
10
20
-
-
12.3mm
13 mm
14.7mm
(0.48")
(0.51")
(0.58")
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
6. Tighten
7. Loosen
4
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
1
012498
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from
the top of the workpiece to the center of the blade
thickness.
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
NOTE:
Remove the angle guide according to the need of
•
your work when using the tool with the angle of the
fence adjusted to other than 0 ﾟ. When you need to
use the angle guide under the above condition, be
sure to adjust the depth of groove to get a proper
depth.
1
MAX
-
*
20 mm
(0.8")
012499
3
10mm
10mm
012500
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
6
2
3
4
5
4
3
2
1
2
4
5
1. Knob
2. Down
3. Up
4. Center of blade
thickness
1. Fence
2. Angle scale
3. Lock lever
4. Tighten
5. Loosen
1. Lock lever
2. Pointer
3. Angle scale
4. Center of blade
thickness
5. Blade cover
