Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1
ROUGHING-IN DIMENSIONS
9-1/2"
(243 mm)
7-1/8"
(182 mm)
(105 mm)
2
INSTALL SPOUT
Turn off hot and cold water
supplies before beginning.
NOTE: must have R910 valve installed before
beginning.
• Apply 4-5 drops of THREADLOCKER (1) on
threads of DIVERTER INSERT (2).
• Drop the DIVERTER INSERT (2) through the
METAL WASHER (6) and then through the
opening of the rough-in valve. Then thread the
DIVERTER INSERT (2) to the Rough-in valve.
• Place the DECORATIVE RING (7) with groove
side facing down on the underside of the
FAUCET BODY (3). Be sure the RUBBER
WASHER (5) is seated in the recess of the
DECORATIVE RING (7).
• Drop the FAUCET BODY (3) with the
DECORATIVE RING (7) onto the DIVERTER
INSERT (2) and secure by tightening the
SET SCREW (4) at the back of the spout.
D
2-7/8"
(73 mm)
4-1/8"
1" MAX.
(25 mm)
22"
(559 mm)
4-5/8"
(117 mm)
5-3/16"
(132 mm)
2-1/2"
(63 mm)
8" TO 12"
FLEXIBLE INSTALLTION
(203 TO 305 mm)
4
3
1
8"
(203 mm)
2-3/16"
(55 mm)
Hex wench
(supplied)
RECESS
7
5
2
6
MOUNTING
SURFACE
