Idiomas disponibles
Idiomas disponibles
WARNING – ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate electrical system that is up to code.
The supply cord has a polarized plug. As a safety feature this plug will fit in a polarized outlet only one way. To prevent
electric shock, match wide blade of plug to wide slot, fully insert plug. If the plug does not fit contact a qualified
electrician.
Do not operate any heater with a damaged cord or plug or after heater malfunctions, has been dropped or damaged
in any manner. Do not operate heater with a broken heating element or ceramic cone or any visual imperfections.
For repairs covered under warranty, see warranty statement. For all other repairs contact us at [email protected].
PET OWNERS NOTE:
The health of birds and some small pets are extremely sensitive to the fumes given off during the initial use of many
appliances. Although these fumes are not harmful to humans, it is recommended that this heater not be used around
birds and small pets during its initial use until the manufacturing corrosion coatings burn off.
INSTALLATION INSTRUCTIONS
HEATER INSTALLATION:
Always operate the heater in the upright position following all instructions and recommendations listed in this manual.
HEATER LOCATION:
Place the heater in the area of the room that is coldest.
HEATER CONNECTION:
Plug heater directly into 120-volt A.C., 60Hz wall outlet. Be sure plug fits tightly in outlet. A loose connection may
cause overheating and damage to the plug or heater.
NOTE:
To prevent overloading a circuit, do not plug the heater into a circuit that is servicing other electrical needs.
OPERATING INSTRUCTIONS
POWER INDICATOR:
near the power control, lights whenever the heater is plugged in.
TURNING HEATER ON:
To start the heater, turn the ON/OFF POWER LEVEL/FAN Dial from the OFF position to the LOW (1300W) or
HIGH (1500W) setting. Then rotate the THERMOSTAT CONTROL clockwise to the HIGH THERMOSTAT position
as described below.
NOTE: During the heaters initial use, you may experience a slight odor or smoking. This is the result of the heating
element fabrication protective coating "burning off". This is normal and will go away after a few minutes of use.
POWER CONTROL DIAL: This heater has two heat settings: High (1500W) and Low (1300W).
Use the higher setting (1500 W) to raise the room temperature quickly. When the desired temperature is reached use
the Low (1300 W setting. It is usually sufficient to maintain a comfortable temperature.
SAVE THESE INSTRUCTIONS
This heater is equipped with a power indicator light. The power indicator light, located
POWER INDICATOR
LIGHT
ON/OFF
POWER LEVEL
and FAN ONLY DIAL
CONTROL PANEL
CAUTION INDICATOR
4
LIGHT
ADJUSTABLE
THERMOSTAT
