Idiomas disponibles
Idiomas disponibles
TOOLS NEEDED
Assemble the required tools before starting installation.
Read and follow instructions provided with any tools
listed here.
• Screwdriver
• Tape measure
• Pliers
If using Soldered Copper Pipe
• Tubing cutter
• Lead-free solder and flux
• Propane torch
• Emery cloth, sandpaper or steel wool
• Misc. copper pipe fittings
If using Threaded Pipe
• Pipe cutter or hacksaw
• Pipe joint compound
• Threading tool
• Misc. threaded pipe fittings
If using CPVC Plastic
• Pipe cutter
• Solvent cement
• Hacksaw
• Primer
• Adjustable wrench
If using Other
• Other pipe and fittings suitable for potable water as
required by piping system manufacturer and local
codes and/or ordinances.
LOCATION
REQUIREMENTS
Consider the following when selecting an installation loca-
tion for the Central Water Whole Home Filtration System.
• Do not operate the Central Water Whole Home
Filtration System where freezing temperatures occur.
Do not attempt to treat water over 120°F. Freezing
temperatures or hot water damage voids the warranty.
• To condition all water in the home, install the Central
Water Whole Home Filtration System close to the
water supply inlet, and before all other plumbing con-
nections, except outside water pipes.
• A nearby drain is needed to carry away Clean Rinse
discharge water. Use a floor drain, laundry tub, sump,
standpipe, or other options (check your local codes).
See "Air Gap Requirements" and "Valve Drain
Requirements"
sections.
If a drain is not available, it is
still possible to operate the Central Water Whole Home
Filtration System in a manual Clean Rinse mode. See
"Operating in Manual Clean Rinse Mode." The auto-
matic Clean Rinse must be disabled if the Central
Water Whole Home Filtration System will not be con-
nected to a drain (See Page 16).
• The Central Water Whole Home Filtration System
works on 24 volt, 60 Hz electrical power only, supplied
by a direct plug-in transformer (included).
Provide an
electrical outlet in accordance with NEC and local
codes.
• Do not install the Central Water Whole Home Filtration
System on a hot water line (See Figure 2 below).
• Install the Central Water Whole Home Filtration
System between the home's incoming water supply
and the water softener, if one is being used (See
Figure 2).
THE PROPER
ORDER TO INSTALL
WATER TREATMENT
EQUIPMENT
Cold Water
to House
Untreated Water to
Outside Faucets
Hot Water
to House
Water
Heater
Water
Softener
Central
Water
Filtration
System
Optional
Sediment
Filter
City Water Supply
t
Pressure
Tank
OR
I Well Water Supply
Well
_
Pump
f
Figure 2
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
