Idiomas disponibles
Idiomas disponibles
Mounting the Solar Panel
1. Place the solar panel against the mounting surface and mark the
mounting holes (see Figure 5).
• If mounting to a wooden surface, drill two 3/32 in. holes into
the mounting surface. Install the two mounting screws through
the base and into the mounting surface.
• If mounting to wall board or brick, drill two 7/32 in. holes
into the mounting surface. Insert the wall anchors and attach
the base using the two mounting screws.
IMPORTANT: Caulk around the base and on top of the screw
heads after installation.
2. Rotate the solar panel to the desired angle (see Figure 5).
IMPORTANT: The solar panel must receive as much direct sunlight
over the course of the day as possible. Keep in mind that shadows
may block the sunlight from reaching the solar panel during the
day.
3. Carefully route the solar panel cable to the light fixture. Plug the
solar panel cable into the connector extending from the bottom
of the light fixture (see Figure 6).
IMPORTANT: Slide the ON-TIME switch on the bottom of the
sensor to the OFF position and allow the battery to charge with
3 to 7 days of full sunshine before testing (see Figure 4).
TESTING AND ADJUSTMENTS
CAUTION: To avoid water damage, motion sensor con-
trols must be facing the ground when installation is complete.
1. Slide the sensitivity (SENS) switch to the "L" position, the
ON-TIME switch to the TEST position, and the ECO POWER
MODE switch to the OFF position (see Figure 4).
2. Walk through the coverage area noting where you are when the
lights turn on. Also, the LED indicator behind the motion sen-
sor lens will glow blue when motion is detected (see Figure 8).
Note: The blue LED will turn off 30 seconds after all motion has
stopped.
3. If needed, gently grasp the motion sensor and move it from side
to side or up and down to adjust the detection zone.
4. If needed, gently grasp the lamp head and move it from side to
side or up and down to adjust the light coverage area.
4
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 5
Figure 6
LED Indicator
Figure 7
Figure 8
210452-02
