Idiomas disponibles
Idiomas disponibles
V. MAINTENANCE
• U
se only a dry, soft cloth for wiping the unit. Do not use a damp cloth, thinner, ben-
zine, or other volatile solvents for cleaning.
•
In the event that the inside of the tool or battery pack is exposed to water, drain and
dry
allow to
as soon as possible. Carefully remove any dust or iron filings that col-lect
inside the tool. If you experience any problems operating the tool, consult with a repair
shop.
VI. ACCESSORIES
CAUTION:
The use of any accessories not specified in this manual may result in fire, electric
shock, or personal injury. Use recommended accessories only.
Bit adapter (included)
•EY9HX403E
Drill chuck
Use with wood drill bit or metal drill bit with shank of 1.5 mm to 13 mm diameter.
Do not use the drill chuck in "Rotation with hammering mode" (
with hammering mode" may cause break of chuck or bit and result in injury.
Hammer chuck
Use with concrete drill bit, wood drill bit or metal drill bit with straight shank of 2.5 mm
to 13 mm diameter.
Do not use the hammer chuck with wood drill bit or metal drill bit in "Rotation with
hammering mode" (
of bit and result in injury.
If you need any assistance for more details regarding these accessories, ask your
local service center.
VII. USAGE SUGGESTION
1. If there isn't enough force pushing down on the bit, the tool may not be able to
blow in hammering mode.
This is to prevent the hammering mode from operating with no load. Press down
harder on the bit to engage the tool and cause it to blow.
2. In winter or in other situations where the temperature of the unit is low (5°C (41°F)
or below), the blow of the hammering mode may be weaker than normal at the be-
ginning stage.
This is because the grease becomes stiffer in low temperatures, increasing fric-
tion.
If this should happen, operating hammering mode with no load for approximately
30 seconds and repeat this 3 times. This will restore its blowing power.
). Use in "Rotation with hammering mode" may cause break
- 19 -
- 19 -
). Use in "Rotation
