General Description - Cebora PLASMA SOUND PC 50M Manual De Instrucciones

The following numbered text corresponds to the label
numbered boxes. The following text corresponds to
the numbered boxes on the label applied on the power
source.
1. Cutting sparks can cause explosion or fire.
1.1 Keep flammable materials away from cutting.
1.2 Cutting sparks can cause fires. Have a fire extin-
guisher nearby, and have a watchperson ready to
use it.
1.3 Do not cut on drums or any closed container.
2. The plasma arc can cause injury and burns.
2.1 Turn off power before disassembling torch.
2.2 Do not grip material near cutting path.
2.3 Wear complete body protection.
3. Electric shock from torch or wiring can kill.
3.1 Wear dry insulating gloves. Do not wear wet or dam-
aged gloves.
3.2 Protect yourself from electric shock by insulating
yourself from work and ground.
3.3 Disconnect input plug or power before working on
machine.
4 Breathing cutting fumes can be hazardous to your
health.
4.1 Keep your head out of fumes.
4.2 Use forced ventilation or local exhaust to remove
fumes.
4.3 Use ventilating fan to remove fumes.
5 Arc rays may injure the eyes and burn the skin. Op-
erators should therefore shield their eyes with lens-
es with a protection rating equal to or greater than
DIN11 and adequately protect their
5.1 Wear hat and safety glasses. Use ear protection and
button shirt collar. Use welding helmet with correct
shade of filter. Wear complete body protection.
6 Become trained and read the instructions before
working on the machine or cutting.
7 Do not remove or paint over (cover) the label.
14

2 GENERAL DESCRIPTION

This equipment is a direct current continuous power
source designed for plasma arc cutting of electro-con-
ducting materials (metals and alloys). Along with the torch
is a single-gas plasma cutting system (air or nitrogen),
completely managed by a microprocessor , capable of
delivering a maximum current of 50 A to 40% utilization
factor.
Different sets of consumables are available as a function
of cutting current, depending on the type of work, cali-
brated and tested for maximum and long lasting cutting
quality .
2.1 DESCRIPTION OF THE EQUIPMENT
(Fig. 1 and Fig. 1/A)
A) Power switch
B) Mains power switch
C) Compressed air fitting (1/4" female gas thread)
D) Pressure gas regulation knob
E) Water trap
F) Interface connector (on request)
G) Grounding clamp
H) Current regulation knob
face.
J) Fixed torch fitting
K) Torch connection protection
M) Mobile torch fitting
N) Power indicator LED (green)
O) Temperature indicator LED (yellow)
P) Power source block indicator LED (red)
Q) Pressure indicator LED (red)
R) Self Restart Pilot LED (green)
S) Button to activate / deactivate the
Z) Pressure gauge
PILOT" function
"SELF RESTART