Idiomas disponibles
Idiomas disponibles
Troubleshooting
7
Problem
Engine Fails to start
Engine runs erratic
Cause
1. Blade control disengaged
(Lawn mower
only).
2. Spark plug boot disconnected.
3. Fuel tank empty or stale fuel.
4. Fuel shut-offvalve
closed Ofequipped).
5. Engine not primed (if equipped
with primer).
6. Faulty spark plug.
7. Reduced fuel flow/Blocked
fuel filter.
8. Engine flooded.
g. Engine not choked (if equipped with choke).
10. Burnt fuse. (Electric Start only)
1. Spark plug boot loose.
2. Reduced fuel flow/Blocked fuel filter.
Remedy
1, Engage blade control,
2. Connect wire to spark boot.
3. Fill tank with clean, fresh gasoline.
4. Turn on fuel shut-off valve.
5. Prime engine as instructed in the Operation
section.
6. Clean, adjust gap, or replace.
7. Replace fuel filteras
instructed
in the
Maintenance
section.
8. Walt a few minutes to restart, but do not
prime.
9. Choke engine. See engine
manual.
10. Replace fuse (see Service Section of Unit).
1. Connectand
tighten
spark plug boot.
2. Replace fuel filter as instructed
in the
Maintenance
section.
3. Ventin
gas cap plugged.
4. Water or dirt in fuel system.
3. Clear vent.
4. Drain fuel tank. Refill with fresh fuel.
5,
6.
Dirty air cleaner.
5.
Unit running
with CHOKE (if equipped)
6.
applied.
Engine oil level low.
1.
Air flow restricted.
2.
Spark plug gap too close.
1.
Refer to engine manual.
Push CHOKE knob in.
Engine overheats
1.
Fill crankcase with proper oil.
2.
Clean area around and on top of engine.
Occasional
skips
1.
Adjust gap to .030".
(hesitates) at
high speed
Idles poorly
1. Spark plug fouled, faulty, or gap too wide.
1. Reset gap to .030" or replace spark plug.
2. Dfftyalrcleaner.
2. Refertoenglnemanual.
