Analogue Input Signals - Signals From Robot To Power Source; General; Available Signals - Fronius RI IO/i Manual De Instrucciones

Analogue input signals - signals from robot to
power source

General

The analogue differential amplifier inputs on the interface ensure that the inter-
face is electrically isolated from the analogue outputs on the robot controller.
Each input on the interface has its own negative potential.
NOTE!
If the robot controller uses only a common GND for its analogue output signals,
the negative potentials, i.e. the inputs on the interface, must be linked together.
The analogue inputs described below are active at voltages of 0 - 10 V. If indivi-
dual analogue inputs are not assigned (for example for Arclength correction) the
values set at the power source will be used.

Available signals

Descriptions of the following signals can be found in the document "Signal de-
scriptions for TPS/i interface".
Signal designation
Wire feed speed command value
(Wire speed set value)
Arclength correction
(Arc length correction set value)
28
Assignment
X2/1 connector = 0 - 10 V
X2/4 connector = GND
X2/2 connector = 0 - 10 V
X2/5 connector = GND