Scheppach DP18VARIO Traduccion Del Manual De Instrucciones Originale página 32

• Never point the laser beam towards reflecting sur-
faces and persons or animals. Even a laser beam
with a low output can cause damage to the eyes.
• Caution - methods other than those specified here
can result in dangerous radiation exposure.
• Never open the laser module. Unexpected exposure
to the beam can occur.
• If the product is not used for an extended period of
time, the batteries should be removed.
• The laser may not be replaced with a different type
of laser.
• Repairs of the laser may only be carried out by the
laser manufacturer or an authorised representative.
m WARNING! This electric tool generates an electro-
magnetic field during operation. This field can impair
active or passive medical implants under certain con-
ditions. In order to prevent the risk of serious or dead-
ly injuries, we recommend that persons with medical
implants consult with their physician and the manu-
facturer of the medical implant prior to operating the
electric tool.
Residual risks
The machine has been built according to the state-
of-the-art and the recognised technical safety re-
quirements. However, individual residual risks can
arise during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "safety in-
structions" and the "Proper use" are observed along
with the whole of the operating instructions.
• Do not unnecessary stress the machine: too much
pressure when drilling will damage the drill quickly.
This results in reduced output of the machine in the
processing and in cut precision.
• Avoid accidental starting of the machine: the oper-
ating button may not be pressed when inserting the
plug in an outlet.
• Use the tool that is recommended in this manual.
In doing so, your drill provides optimal performance.
• Keep your hands away from the working area when
the machine is in operation.
Before performing setting or maintenance work, switch
the device off and unplug the mains plug.
32 | GB
6. Technical data
Rated input voltage
Nominal power
Motor speed
Output speed (continuously
adjustable)
Chuck adapter
Drilling spindle cone
Chuck
Drilling table size
Base plate size
Angle adjustment
Drilling depth
Column diameter
Machine dimensions L x
W x H
Weight
Laser class
Laser wavelength
Power of laser
Subject to technical modifications!
Noise
The noise values have been determined in accordance
with EN 62841.
Sound pressure level idle mode L
Uncertainty K
Sound power level idle mode L
Uncertainty K
Wear ear-muffs.
Excessive noise can result in a loss of hearing.
The above-mentioned noise emission values were
measured in accordance with a standardised test pro-
cedure and can be used to compare one power tool
with another.
The specified device emissions values can also be
used for an initial estimation of the load.
www.scheppach.com
230-240 V~ 50 Hz
750 W / S2 10 min
440 - 2580 rpm
240 x 240 mm
540 x 390 x 950 mm
pA
pA
WA
WA
1450 rpm
B16
MT2
1 - 16 mm
410 x 250
45° - 0° - 45°
80 mm
65 mm
38.5 kg
2
650 mm
1mW
72.1 dB
3 dB
84.2 dB
3 dB