Idiomas disponibles
Idiomas disponibles
Jandy
Figure 3.
Remove Transformer and Output Wires
9.
Remove the old transformer from the Light Controller.
10. Attach the new transformer blue output wires to output wire
screws in Light Controller and tighten.
11. Plug the new white transformer input wire connector harness to
the Light Controller.
12. Place the new transformer on the Light Controller mounting bolt.
13. Place gasket, transformer washers, and transformer nut on Light
Controller mounting bolt and tighten with 14mm wrench.
14. Replace the Light Controller lid on the Light Controller.
15. Replace Light Controller lid screw and tighten.
16. Turn the power on at the breaker panel.
Page 8
Infinite WaterColors
®
LED Light Controller | Spare Parts Installation Manual
™
