Jandy JLPBBL Instrucciones De Instalación

FOR YOUR SAFETY - This product must be installed by a licensed HVAC technician certified in heat pump repair and
maintenance by the jurisdiction in which the product will be installed where such state or local requirements exists. The
technician must possess and comply with all certifications and regulations regarding the purchasing, handling, transportation
and reclamation of R410A refrigerant. In the event no such state or local requirement exists, the installer or maintainer must
be a professional with sufficient experience in pool equipment installation and maintenance so that all of the instructions in
this manual can be followed exactly. Before installing this product, read and follow all warning notices and instructions that
accompany this product. Failure to follow warning notices and instructions may result in property damage, personal injury, or
death. Improper installation and/or operation can create an electrical hazard which can cause serious injury, property damage,
or death. Improper installation and/or operation may void the warranty
These instructions are to be used with the following Jandy Replacement Kits:
R0960900 -- Laminar Jet with RGBW LED Light Replacement Kit
JLPBBL -- Laminar Jet Lid and Collar, Pebble
JLPWTR -- Laminar Jet Lid and Collar, Pewter
If the information in these instructions is not followed exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
RISK OF ELECTRIC SHOCK WHICH CAN RESULT IN SERIOUS INJURY OR DEATH. Before
attempting installation or service, ensure that all power to the device is disconnected/turned off at the
circuit breaker.
This document gives instructions for replacing an
existing laminar jet with a Jandy Laminar Jet with LED
Light.
The instructions were written with safety as the priority
and must be followed exactly. Not following the written
procedure or taking shortcuts may increase the risk
of personal injury. Read through the instructions
completely before starting the procedure.
Before starting the procedure, use the parts list at the
back of these instructions to identify the parts that are
in your kit. If any parts are missing from the kit please
call your local distributor for assistance. For technical
assistance, please contact our Technical Support
Department at 1.800.822.7933 (US and Canada) or
1-800-688-552 (Australia).
Laminar Jet with RGBW
LED Light Replacement Kit
Installation Instructions
WARNING
WARNING
WARNING
A. Retrofitting a Jandy JDJ1001 Laminar
Jet
1. Remove the two (2) screws that secure the laminar
jet cover.
2. Lift up the cover/jet housing assembly and unscrew
the two (2) flexible PVC hose union fittings that are
attached to the bottom of the jet housing.
3. Unscrew the fiber optic fitting on the bottom of the
housing to release the fiber optic cable. See Step 9
before removing the fiber optic cable.
4. Remove the cover/jet housing from the canister.
5. If the canister is installed in a planter, the collar
can be replaced by pulling the old collar out of the
canister and installing the new one.
NOTE The collar can not be removed from the canister
if the laminar jet canister is already installed in
the concrete pool deck. In this case, the new lid
can be used with the old canister collar.
*Fiberstars is a registered trademark of Energy Focus, Inc.
**Pentair is a registered trademark of Pentair, Inc.