Behringer DIGITAL REVERB DR600 Manual Del Usuario página 3

2 DIGITAL REVERB DR600
The two 1/4" TS connectors OUT A and OUT B send the signal to
(8)
your amp. Use both connectors if you want to achieve full stereo
effect. For mono use just plug in OUT A.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery (not included), press the hinges with
a ballpoint pen and remove the pedal cover. Be careful not to scratch
the unit.
◊ ◊
The DR600 has no on/off switch. As soon as you insert the
jack into the IN connector, the DR600 begins running.
When not using the DR600, remove the jack from the IN
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualified servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
3. Limited Warranty
For the applicable warranty terms and conditions and additional
information regarding Music Tribe's Limited Warranty, please see
complete details online at musictribe.com/warranty.