Operation - Ryobi GDM800 Manual Del Operador

WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Do not leave items to be inflated unattended while inflator
is in use. These items can burst and could cause serious
injury.
NOTICE:
The inflator is not designed for continuous use. For every
5 minutes of inflator use, 5 minutes of cool down time
are required.
WARNING:
Since the pressure gauge is not calibrated, and is
therefore not binding for exact values, tire pressure must
be checked using a reliable measuring device before
driving a vehicle with vehicle tires inflated with the inflator.
Driving a vehicle with improperly inflated tires could result
in serious injury.
NOTICE:
The inflator is capable of inflating to 145 psi. To avoid
over inflation, carefully follow instructions on items to
be inflated. To avoid product damage, never exceed
recommended pressures.

OPERATION

APPLICATIONS
You may use this inflator for the purpose listed below:
 Inflating items such as motorcycle, car, and bicycle tires
NOTE: The inflator is not designed for commercial appli-
cations.
ACTIVATING/DEACTIVATING DC ACCESSORY
PORTS
See Figure 5, page 11.
 To activate a DC accessory port, press the number on
the indoor keypad (not included) corresponding with the
desired port. For example, to activate accessory port #1
press NUMBER 1 on your keypad.
NOTE: Multiple ports can be activated at once.
 To deactivate a DC accessory port, press the number on the
indoor keypad (not included) corresponding with the port.
I N S T A L L I N G / R E M O V I N G
ACCESSORY
See Figures 5 and 6, pages 11 and 12.
WARNING:
Ensure the accessory is properly and securely connected
to the port on the garage door opener. Failure to properly
secure the accessory can cause it to fall and could result
in serious injury or property damage.
WARNING:
Use extreme care if you need to stand on a ladder to
install or adjust this accessory. Ensure someone is
holding the ladder on the ground to keep it stable. Failure
to safely use a ladder can cause a fall and result in death
or serious personal injury.
 Assemble and mount the garage door opener as
described in the RYOBI Garage Door Opener operator's
manual.
 Connect the garage door opener to an AC power supply.
 Select one of the AC receptacles on the opener to power
the inflator.
NOTE: The garage door opener has two 120 Volt AC
GFCI protected receptacles with a combined rating of 10
Amps. These can be used for operating AC garage door
accessories as well as appropriate appliances, electrical
lighting, and tools.
 Remove both accessory port covers on the side where
you will install the accessory.
 Hook the inflator accessory to the four slots and insert
it into the AC receptacle and either accessory port #1
(right side installation) or accessory port #5 (left side
8 - English
I N F L A T O R