Idiomas disponibles
Idiomas disponibles
9.4 CHANGING A PROGRAMME
In order to change a cycle that is already running, press the Power button (A), all settings will
be deleted.
In order to set a new cycle, press the Power button (A) again to turn on the appliance and then
press the P button (D) to select the new washing mode.
As the programme is being changed, the dishwasher detergent may have already been used
and the appliance may have already drained the washing water. In this case, the dishwasher
detergent needs to be replenished.
9.5 STOPPING A PROGRAMME
• CAUTION! There is a risk that water sprays out from inside the appliance. Only open the door
fully when the spray arm is no longer rotating.
First press the Start/Pause button (F) and then open the door.
If the appliance had already heated up or the hot water was turned on and the appliance door
was opened, leave the door ajar for a few minutes and then close it.
9.6 END OF THE PROGRAM
Six acoustic signals indicate that the wash cycle has ended and the dishwasher is turned off.
Open the door a few minutes after the programme has ended.
Close the tap.
Remove the crockery etc. when it has cooled.
10.0 MAINTENANCE AND CARE INSTRUCTIONS
Always switch off the appliance and disconnect the power plug before carrying out maintenance
or inspection work.
Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
Parts should only be replaced with original spare parts, and by an expert, in accordance with the
manufacturer's specifications. A lack of care and maintenance can damage the appliance.
Dangerous situations can arise. To ensure electrical safety, the appliance must not be subjected
to liquids or be immersed in them. Regular maintenance helps to ensure the safety of the product
and increases its service life.
10.1 CARE TIPS
Turn off the water supply to the appliance after each wash cycle and leave the door open
slightly to prevent moisture and odours developing inside.
Always disconnect the power plug from the mains socket before cleaning or maintenance.
Do not use solvents or abrasive products to clean the outer or rubber parts of the dishwasher.
Use a cloth and warm soapy water for cleaning instead.
To remove stains on the surface of the inside, use a damp cloth or a detergent especially
formulated for dishwashers.
If you need to move the appliance, try to keep it in a vertical position. If absolutely necessary,
the appliance may be placed on its back.
Food that remains stuck in the seals is one of the factors that leads to odours developing in
the dishwasher. To prevent this, clean regularly with a damp cloth.
The door should not be left completely open, as this could be a tripping hazard.
If you go away on holiday, it is recommended to run a wash cycle with the dishwasher empty
and then remove the plug from the socket, turn off the water supply and leave the door of the
28
www.DEUBAXXL.de
