Idiomas disponibles
Idiomas disponibles
3.2.
Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less
than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least
10 cm distance between each side of the device and the wall or other objects. The device should always be
used when positioned on an even, stable, clean, fireproof and dry surface, and be out of the reach of
children and persons with limited mental and sensory functions. Position the device such that you always
have access to the power plug. The power cord connected to the appliance must be properly grounded
and correspond to the technical details on the product label.
The installation site must have adequate ventilation (e.g. hood).
Before first use, disassemble all parts and clean them as well as the whole device.
Fully unpack the device and remove the protective film before first use. The packaging material may melt
or catch fire through contact with the hot device.
3.3.
Assembling the device
Fit the handles to the heating plates.
Place the drip tray on the device housing to prevent dough from flowing out form between the heating
plates.
3.4.
Device use
CAUTION! It is not recommended to eat the first few prepared waffles.
CAUTION: Before using the device for the first time, wash and grease the heating plates thoroughly and
then preheat the device without dough.
While the device is heating up there a little smoke may appear - this is perfectly normal. You should only
take care of proper ventilation. After a few minutes, turn off the device and wait until it cools down, then
grease the heating plates - the device is ready for use.
1) Make sure that the thermostat knob [A] is set to „MIN" and the I/O switch [E] is set to „O".
2) Connect the device to the power supply.
3) Switch on the device by setting the I/O switch [E] to the „I" position.
4) Turn the thermostat knob [A] to select the desired temperature. The heating control [B] will light up
and the device will start heating. The heating elements will automatically maintain the set
temperature using the thermostat. The heating plates should remain closed while the device is
heating up.
5) When the device has reached the set temperature, carefully open the upper heating plate by grasping
the handle [1] (grease the heating plates if necessary), spread a suitable amount of the previously
prepared dough on the lower heating plate, close the device and by turning the handle spread the
dough over the heating elements.
6) To remove the ready waffles, place the heating plates in the initial position and carefully open the
device (watch out for high temperature). Waffles should be removed with a spatula made of wood or
plastic. Do not use sharp metal objects, so as not to damage the coatings on the heating plates.
7) After the end of baking, grease the heating plates again, if necessary.
8) Always keep the heating plates when the device is not used.
9) To switch off the device set thermostat knob [A] to „MIN", set the I/O switch [E] to the „O" position
and then unplug the device from the power supply.
EN
