Idiomas disponibles
Idiomas disponibles
CAUTION: Before performing any
service and adjustments:
1. Stop engine.
2. Make sure the rotating lines and all
moving parts have completely
stopped.
3. Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
TRIMMER
TO ADJUST
TRIMMING
HEIGHT
See "TO ADJUST TRIMMING HEIGHT" in the
Operation section of this manual.
TOADJUSTHANDLE
The upper handle may be adjusted to
different
height positions.
• Loosen handle knob only enough to
allow the upper handle to pivot to the
desired
position.
• Tighten
handle knob securely.
NOTE: The handle knob and bolt may be
reversed for left handed operation.
Upper handle
II
TO REMOVE/REPLACE
TRIMMER HEAD
DRIVE BELT
1. Remove screw at front of chassis
cover.
2. Lift cover up and away from trimmer.
Chassis
_ver
3.
Remove the two (2) screws on sides
of trimmer securing the debris shield.
4. Turn trimmer on its side with carbure-
tor and fuel cap up.
5. Remove the two (2) screws on
underside
of trimmer securing the
debris shield.
Slide the debris shield rearward
and
.
7.
remove.
Remove belt from engine pulley on
crankshaft.
En(
pulley
Handle knob
Debris
shield
screws
13
