Idiomas disponibles
Idiomas disponibles
sides and 10 cm above for good air circulation
around the unit.
Place the appliance at a suitable distance from
·
the wall using the spacers if they provided in the
accessory bag.
Your appliance has been designed for optimum
·
performance in a room temperature. We then say
that it is designed for a special "climate class".
This climate class is clearly stated on the rating
plate located inside your appliance, on the left
wall down. Beyond these temperatures, the
performance of your appliance may be reduced.
Classe
Temperature
SN
from + 10°C to + 32°C
N
from + 16°C to + 32°C
ST
from + 16°C to + 38°C
T
from + 16°C to + 43°C
Advice:
After installation of your appliance, set its feet so
that it is slightly tilted backwards, it will facilitate
the closing of the door.
Before putting food, clean the interior and exterior
of your appliance with bicarbonate of soda
dissolved in water (1 tablespoon of bicarbonate for
4 litres of water). Do not use alcohol, abrasive
powders or detergents which could damage the
surfaces. (See chapter "Cleaning your appliance").
ELECTRICAL CONNECTION
The electrical installation must comply with the
applicable standards and must be able to
withstand the maximum power indicated on the
rating plate.
The plug must be properly grounded.
We cannot be held responsible for any incident
caused by defective electrical installation.
Electrical Installation Tips
• Do not use extension cable or adapter or power
strip.
• Never remove the grounding.
• The socket must be easily accessible but out of
reach of children.
In case of doubt, ask to your installer.
Your device is compliant with EU directives and
their modifications.
ENERGY SAVING
To reduce the power consumption of your
appliance:
• Install it in a suitable location (see "Installing
your appliance").
• Keep doors open for as short time as possible.
• Do not put hot food in your refrigerator or
freezer, particularly if they are soups or
preparations which emit a large amount of steam.
• Ensure the optimal functioning of your device by
not letting accumulate too much frost in the
freezer (defrost it when the ice thickness exceeds
5-6 mm) and periodically cleaning the condenser
(see "Maintenance your device ").
• Regularly check the door seals and make sure
that they always close effectively. If this is not the
case, please contact service after sales service.
• Do not let it set at too low a temperature.
• Not fulfilling with drawers, bins and shelves
arrangement could lead to increased energy
consumption.
WARNING:
If the unit was shipped to home in a horizontal
position, place it vertically and wait two hours
before plugging it in. A small amount of oil may
have flowed into the refrigeration circuit, you need
to give it time to flow back towards the motor
before connecting the appliance, otherwise you
may damage it.
Before any maintenance, disconnect the power
plug. Do not pull the power cable but directly enter
the profile.
6
