Kesser K-HB-X10 Manual De Instrucciones página 21

8. shipping and maintenance
Electric self-balancing vehicles require regular maintenance from the user.
This chapter describes maintenance steps and important tips for operation.
Make sure that the mains cable and the charging cable are disconnected before carrying out the
following operations. If the battery is charging, the operation is not allowed.
8.1 Cleaning electric self-balancing vehicles
Disconnect the charger and switch off the self-balancing electric vehicle. 2.
Wipe off the cover.
WARNING: Avoid using water or other liquids to clean the self-balancing electric vehicles. . If water or
other liquids enter the interior of the self-balancing electric vehicle, it will cause permanent damage to
the internal electronics.
8.2 Store self-balancing electric vehicles. 1.
Charge the battery fully before storing it. 2.
If you store the self-balancing electric vehicle for more than one month, please remove the battery and
charge it at least every three months. 3.
3. if the ambient temperature is below 0 ℃（indoor） during storage. please do not charge. You can
bring the electric self-balancing vehicle into a warm environment (10 ℃~25℃) for charging.
4. To prevent dust from entering the self-balancing electric vehicle, you should cover the self-balancing
electric vehicle.
5. store the self-balancing electric vehicle in a dry and temperature-controlled room. If you do not use it
for a long time, please do not connect it to the power supply. 6.
6. prolonged exposure to UV rays, rain and weather may damage the housing materials; store the
vehicle indoors when not in use.
WARNING: Users who disassemble electric self-balancing vehicles without permission will void the
warranty.
WARNING：Fire hazard - No user serviceable parts.
9. parameters of electrically self-balancing vehicles
Model
Parameter 685×223×234mm
Nettogewicht
Maximum Lastgewicht
Minimum load weight
Maximum speed
MaximumRange
Maximum Kletterlimit
Minimum turning
radius
Model
Max. Prüfspannung
Low-Air-
Warnspannung
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
Electric self-balancing vehicles parameters
KD3685PA
Charging current
12.5 ±0.1 kg
100 kg Protection levels of the housing
20 kg Installing the balancing device
10 kph
14 km Ground clearance
10° Platform height
Null
Leiterplattenparameter
YK190A
DC 43V Maximum current
DC 34±0,5V Service Frequency
www.eshopping.de
21
Power
Output
Tire
Voltage
AC100-240V/50-60 HZ
DC 42V,1.5A
≤15A
≥IP34
AND
8.5 inches
23±3mm
113±5 mm
DC 36V
13±1A
16k