Idiomas disponibles
Idiomas disponibles
INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
25 to 36 inches (635mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 14 inches (356mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
14" min
1
Interior wall "- .... *
FIG. 1
INSTALLATION
HARDWARE
ITEMA:lEA
ITEMB:lEA
(SUPPORT SILL
(LEVELING
BRACKET)
BOLT)
ITEME:12EA
ITEM F: 4EA
(5/16" SCREW) (9/16" S CREW)
ITEM J: lEA
(SEAL STRIP)
(Adhesive backed)
m
ITEMC:2EA
ITEMD:2EA
(LOCKING
NUT) (5/8" S CREW)
ITEMG:lEA
ITEM H: lEA
(SASH LOCK) (SEALSTRIP)
(Adhesive
backed)
G--
ITEM K:1EA
(SASH SEAL)
(Notadhesivebacked)
E
ELECTRICAL
SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on left side of cabinet),
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections. SAVE CARTON
and this OWNER'S MANUAL for future reference.
The carton is the best way to store unit during
winter or when not in use.
To avoid risk of personal injury, properly damage,
or product damage due to the weight of this
device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• Carefully inspect location where air conditioner
will be installed.
Be sure it will support the weight of the unit over
an extended perior of time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rear coils.
• Make sure air conditioner does not fall during
installation.
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• Carpenters level
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratcher
• Tape measure
• Electric ddll
• 1/4-inch drille bit
-5-
