Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4 If necessary shorten platic hose according to the
table and insert it up to the collar into the
shorter blue marked copper pipe.
5. Connect the shorter, blue marked supply pipe to
the angle valve.
Connect the longer blue marked pipe to the
inlet and the red marked to the outlet of the
storage tank.
6. Connect the pull rod to the pop-up waste.
Attention!*
With water heaters of 5 liters the flow rate at the
mixer should not exceed 5 l/min.
In this case the flow rate must be reduced at the
angle valve.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
When the storage tank is being heated, the spout
will drip.
When changing the spray former, it is imperative to
use one made for this type of mixer.
max. permissible water
pressure on the spot
in bars
1 - 1,5
2 - 3
4 - 7
Hose lengths to be used
8, 10 and 15 liters
without hose
hose to be short
If pressure greater than 5 bar, fit pressure reducer.
English
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow with water heaters
of 5 liters:
Spare parts
1
lever head
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
spray former
6
pull rod
7
fixation cpl.
XXX = Colors
000 chrome plated
090 chrome plated/gold plated
880 satin chrome
storage tank volume
ened to 90 mm
hose unchanged,
reduce flow rate at the angle valve*
up to 5 liters
hose to be shortened to 90 mm
hose unchanged
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
max. 5 l/min
96338000
94192XXX
94194000
92730000
94033XXX
92620XXX
96016000
