Idiomas disponibles
Idiomas disponibles
Subwoofer Controls
Power On/Auto/Standby
Plug the subwoofer AC cord into a wall outlet. We do not recommend using the outlets on the back of the receiver. Set the
power switch to the desired setting.
OFF – The subwoofer is off and will not produce any sound. You may want to turn your subwoofer off if you will not be
using it for some time or wish to conserve electricity.
AUTO – The subwoofer will power on whenever a signal is detected. If no signal is detected after several minutes, it will
automatically enter the Standby mode.
ON – The subwoofer is always on.
An LED indicator next to the volume control indicates what mode the subwoofer is in.
OFF = The subwoofer is off
RED = STANDBY (No signal detected, Amp Off )
GREEN = ON (Signal detected, Amp On)
The subwoofer will automatically enter the Standby mode after several minutes when no signal is detected from your system.
The subwoofer will then power ON instantly when a signal is detected.
Volume Control
Begin by adjusting the Subwoofer Volume Control to the 11 o'clock position. Further adjust the Subwoofer Volume Control
until you hear a match in volume between the main speakers and subwoofer. Ideally, bass response should not overpower
the room but rather be adjusted so there is a natural blend across the entire musical range.
Polarity Control
Selects regular (0°) or inverted (180°) polarity for the subwoofer. Set this switch to the position that provides the fullest, most
dynamic bass when auditioned from the primary seating position. The effect of polarity will be most audible on low-frequency
percussion instruments or music with a continuously repeating bass line, and may not produce a dramatic change at all.
Operation
When using the MCS 150 in a Dolby® Digital or DTS™ home theater system, make sure all speakers are set to "Small". When
using the system in a Dolby Pro Logic® home theater system, make sure the receiver's center channel mode is set to "Normal. "
Some receivers/processors offer different setup options for each source or surround mode (e.g., CD-stereo, videotape, Dolby
Digital, Dolby Pro Logic). In each case, follow your equipment's instructions to ensure that the subwoofer output is turned on
and that the speakers are set to "Small" in each mode.
If your receiver has adjustable crossover settings, we recommend the subwoofer crossover be set at 120Hz.
Refer to the owner's manual for your AV receiver for any additional recommendations on system operation.
6
142-003871-0_MCS_150_Manual.indd 6
MCS 150
VOLUME
POLARITY
LINE IN
ON
180 º
AUTO
MIN
MAX
OFF
0 º
T2.5A/250V
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
120V~
60Hz
300W
AUDIO/VIDEO
APPARATUS
86AC
LED Indicator
8/31/10 4:40 PM
