Idiomas disponibles
Idiomas disponibles
ALiGNiNG
SPLITTER
BRACKET
Fig. 20A-2
MAKE CERTAIN the table saw is disconnected from
the power source.
Fig. 20A=1
A
B
To adjust front splitter bracket (A), loosen the two
hex socket head cap screws (B). See Fig 20A-1
\
2,
3,
4,
5,
Place a straight edge(C) along the left side of blade
(D) and adjust the front splitter bracket to align the
splitter (E) with the blade. See figure 20A-2.
Retighten the two hex socket head cap screws after
the splitter has been aligned.
If necessary, adjust the rear splitter bracket (F)
make certain that entire splitter is in line with the
saw blade. See figure 20A-2.
Recheck to make certain the splitter is still square
to the saw table. If adjustments are necessary, see
BLADE GUARD AND SPMTTER ASSEMBLY.
31
