Idiomas disponibles
Idiomas disponibles
TOOLS
REQUIRED
The following tools are needed for assembly and align-
ment. Note: Two blade wrenches and five hex wrenches
are provided with your table saw. The remaining tools
are typical shop tools and are not included with your
table saw.
18mm wrench
13mm wrench
10mm wrench
8mm wrench
3/16-in. hex wrench
#2 Phillips screwdriver
• The table saw is a heavy machine; two people are
required for certain assembly operations.
• DO NOT assemble the table saw until you are sure
the tool is unplugged.
• DO NOT assemble the table saw until you are sure
the power switch is in the "OFF" position.
• For your own safety, DO NOT connect the machine to
the power source until the machine is completely
assembled and you read and understand the entire
Owner's Manual.
CABINET
LEG ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
1.
Turn the table saw upside down onto its cast iron
table. CAUTION: The table saw is heavy; two peo-
ple are required for this operation.
Be sure to lay
cardboard on the floor to protect the table surface.
Figure
44
2.
Attach leg assemblies (A) to the front (B) and rear
(C) of the table saw cabinet by placing (D) eight
M8 x 25mm hex head screws and eight M8 flat
washers down through the mounting holes in the
leg assembly and cabinet (E). Place an M8 flat
washer, M8 lock washer and M8 hex nut onto each
of the eight screws attaching leg assembly to cabi-
net. Do not completely tighten hardware at this
time. See figure 4-1.
3.
Attach two tie bars (F) inside and between front and
rear legs already attached to the cabinet with (G)
eight 5/16-18 x 5/8" carriage head screws, 5/16" flat
washers, 5/16" lock washers and 5/16-18 hex nuts
and securely tighten all hardware.
See figure 4-1.
POLY=V BELT ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure
5=1
/
A
o " ll
F
C
1.
2.
3.
4.
Make sure all packaging material has been
removed from inside the cabinet.
Open the motor cover and place the motor Poly-V
belt (A) over the blade pulley (B). See figure 5-1.
Carefully lift the motor (C) and place the belt under
the motor pulley (not shown).
Make sure all the v-
notches in the belt are mated with the v-notches of
the blade and motor pulley. See figure 5-1.
Carefully let the motor down and close motor cover.
15
