Idiomas disponibles
Idiomas disponibles
Figure
10=5
s
M
Figure
10=7
AB
AC
\
W
V
9,
Assemble the left side rear rail (M) to the left rear
side of the table saw (N). Attach rear rail (M) to
table (N) with two M8 x 25mm hex button head
screws, M8 flat washers, and M8 Iockwashers (O).
Attach rear rail to extension wing with one M8
x 35mm hex button head screw, M8 flat washer,
M8 Iockwasher, and M8 hex nut (P). Make sure
that the rear rail is below the bottom of the miter
gauge slots (R) in the saw table. See figure 10-5
and 10-6.
10. Slide rear rail connector (S) into the left rear rail
already assembled.
See figure 10-5.
Figure
10=6
R
T
11. Slide the right side rear rail (T) onto rear rail con-
nector. Assemble the right rear rail with two M8 x
25mm hex button head screws to the saw table
and one M8 x 35mm hex button head screw, M8
flat washer, M8 lock washer and M8 hex nut to the
extension wing. See figure 10-6.
12. Using a combination square, make sure the rear rail
is level to the saw table and extension wings and
below the bottom of the miter gauge slots, then
securely tighten all hardware.
13. Assemble the two cursors (U) to the rip fence
assembly (V) using four M5 x 16mm pan head
screws and M5 lock washers (W). See figure 10-7.
14. Lift up on the rip fence handle (X) and place the
fence down onto the saw table with the fence body
into front rail. With the rip fence lock handle up,
you can slide the fence back and forth across the
saw table. Pushing the rip fence lock handle down,
this will lock the fence from moving. See figure 10-7.
15. Align left fence side (AB) at a distance from the
right side (AC) of the right miter gauge groove and
lock the fence.
See figure 10-7.
16. Use a measuring tape to measure the distance
from the saw blade right side to the left fence side.
17. Assemble the cursor (U) to the right side of fence
cross arm with two M5 x 16mm pan head screws
and M5 Iockwashers (W). Do not completely tighten
screws.
See figure 10-7.
18. Align cursor with the scale (Z) so that the thin black
line (Y) is on the same number as the distance
measured in step 16. Tighten the cursor screws.
19. Remove fence from table and reposition it on left
side of saw blade. Align right fence side at a dis-
tance from the left side of left miter gauge groove
and lock the fence.
20. Use a measuring tape to measure the distance
from the saw blade left side to the right fence side.
21. Assemble the second cursor to left side of fence
cross arm with two M5 x 16mm pan head screws
and M5 Iockwashers. Do not completely tighten
screws.
22. Align cursor with the scale so that the thin black line
is on the same number as the distance measured in
step 20. Tighten the cursor screws.
20
