Idiomas disponibles
Idiomas disponibles
Use extra caution when the guard assembly
is removed for resawing, dadoing, rabbeting
or molding. Replace the guard as soon as that
operation is completed.
Use auxiliary facing on miter gauge to
increase stability and control. Crosscutting
operations are more conveniently worked and
with greater safety if an auxiliary wood facing
board is attached to the miter gauge. See "Rip
Fence Auxiliary Facing."
Avoid awkward operations and hand
positions where a sudden slip could cause
fingers or hand to move into the sawblade or
other cutting tool.
If you stall or jam the sawblade in the
workpiece, turn saw OFF and disconnect the
battery pack, remove the workpiece from the
sawblade, and check to see if the sawblade
is parallel to the table slots or grooves and
if the riving knife is in proper alignment with
the sawblade. If ripping at the time, check to
see if the rip fence is parallel with the sawblade.
Readjust as indicated.
Think Safety. Safety is a combination of
operator common sense and alertness at all
times when the table saw is being used.
People with electronic
DANGER
devices, such as
pacemakers, should consult their
physician(s) before using this product.
Operation of electrical equipment in close
proximity to a heart pacemaker could cause
interference or failure of the pacemaker.
WARNING
Drilling, sawing, sanding or machining wood
products can expose you to wood dust, a
substance known to the State of California to
cause cancer. Avoid inhaling wood dust or use
a dust mask or other safeguards for personal
protection. For more information go to
www.P65Warnings.ca.gov/wood
WARNING
Some dust created by power sanding, sawing,
grinding, drilling and other construction activities
contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm. Some examples of these
chemicals are:
Lead from lead-based paints.
–
Crystalline silica from bricks, cement, and
–
other masonry products.
Arsenic and chromium from chemically-treated
–
lumber.
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
Work in a well-ventilated area.
–
Work with approved safety equipment, such as
–
dust masks that are specially designed to filter
out microscopic particles.
Avoid prolonged contact with dust from power
–
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing
and wash exposed areas with soap and water.
Allowing dust to get into your mouth or eyes or
to lie on the skin may promote absorption of
harmful chemicals.
-8-
