Idiomas disponibles
Idiomas disponibles
How to Stop Your Cleaning System
1.
Release spray gun trigger and let engine idle for two
minutes.
2.
Move throttle to SLOW position, then STOP position.
WARNING
Backfire, fire or engine damage could occur.
• DO NOT stop engine by moving choke lever to "Choke" position.
3.
ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to release retained high water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
4.
Engage trigger lock on spray gun when not in use.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your ProjectPro® nozzles, HydroFoam™ launcher, spray
gun and nozzle extension. There is also a hook at the front of
the accessory tray to hold your high pressure hose. Identify
all accessories with the illustration on page 6.
NOTE: The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle. The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1.
Place nozzle extension through hole on accessory tray,
as shown.
2.
Place spray gun through hole on accessory tray on right
side of unit.
3.
Insert multi–colored ProjectPro® nozzles in spaces
provided in accessory tray.
4.
Insert HydroFoam™ launcher in space provided in
accessory tray next to the multi–colored ProjectPro®
nozzles.
5.
Hang high pressure hose on hook attached to accessory
tray on front of tray as shown.
How to Use ProjectPro® Nozzle System
The quick–connect on the nozzle extension allows you to
switch between three different ProjectPro® system nozzles.
ProjectPro® nozzles can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
ProjectPro® nozzles vary the pressure and spray pattern as
shown.
High Pressure
Delicate
40° Yellow
2350 PSI
2.7 GPM
Follow these instructions to change ProjectPro® nozzles:
1.
Engage trigger lock on spray gun.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange ProjectPro® nozzles without locking the
trigger lock on the spray gun.
• DO NOT twist ProjectPro® nozzles while spraying.
2.
Pull back collar on quick–connect and pull current
ProjectPro® nozzle off. Store ProjectPro® nozzles in
holder provided on the accessory tray.
13
General
Max
0° Red
15° Orange
3000 PSI
2675 PSI
2.3 GPM
2.5 GPM
WARNING
