Parkside PABS 20-Li G8 Traduccion Del Manual De Instrucciones Originale página 27

The arrow on the direction switch indicates
the working direction.
1. Wait for the device to shut-down.
2. Push the direction switch (11) into the
desired position:
Clockwise direction: To drill and screw
in screws. There is a forward arrow on
the direction of rotation switch.
Press right on the rotary direction
switch.
Counter-clockwise direction: To un-
screw screws. There is an arrow po-
inting backwards on the direction of
rotation switch.
Press left on the rotary direction switch.
3. Switch lock: Bring direction switch to
neutral position.
The direction changed may only be
performed in standstill mode.
Torque setting
You­can­preset­the­maximum­torque­by­ro-
tating­the­torque­adjustment­ring­(3).­
25 torque settings + 1 drill setting are
provided.
1.­ Turn­the­adjusting­ring­(3)­to­select­the­
desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
­ Torque­adjustment­should­only­be­
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.
lowest torque,
highest torque.
Steps 1 - 25
Step .
Tool change
1. Rotate the keyless chuck (2) counter-
clockwise, until the drill chuck aperture
(1) is large enough to accommodate
the tool.
2. Push the tool as far as possible into the
keyless chuck (2).
3. Rotate the chuck clockwise to clamp
the­tool­firmly.
4. To remove the tool again, rotate the
keyless chuck (2) and pull out the tool.
There is a bit holder (
magnet on the left and right of the
housing.­You­can­attach­one­bit­at­
a time to the bit holder.
Switching on/off
By using the on/off switch (12) you can pro-
gressively control the speed. The longer you
push the on-off button, the higher the speed.
1. Press the on/off switch (12) to start the
device.­The­LED­work­light­(10)­lights­
up during operation.
2. To turn it off, release the on/off switch
(12). When you move the direction
switch (11) to the middle position,
the device is secured against being
switched on.
During breaks in work, the device
can be hung from a belt, using the
integral metal clip (
care to ensure that the device is
switched off and secured against
accidental activation.
The metal clip is also suitable for
opening bottles with bottle caps.
GB MT
5) with
15). Take
27