4 Instrucciones de instalación y montaje
Tambor con dos correas: Media vuelta como minimo.
¡Precaución!
El prebobinado de la correa o cable puede causar un fallo y posibles lesiones con cargas elevadas.
Allowed angles belt & wire
When two belts are mounted opposite each other on 1 drum, there is no restriction in applied direction of the belts. If
only one wire or belt is mounted on a drum, the allowed directions are limited, as stated below. All other angles are not
allowed.
Drum on this side
(2 mounting feet)
1.
Single drum with one belt. The drum is mounted on the right side of the KL300 MultiWinch (the side with two moun-
ting points on the housing). In this situation it is possible to pull 340 kg in every direction, as shown in the picture
above.
2.
Single drum with two belts in opposite direction, it is always best to mount the drum on the right side of the KL300
MultiWinch (the side with two mounting points on the housing as shown in the picture above), but it is not required.
In this situation it is possible to pull 170 kg with each belt (340 kg) in total because of the available torque of the
KL300 MultiWinch).
3.
Single drum with one belt. The drum is mounted on the left side of the KL300 MultiWinch (the side with one moun-
ting point on the housing). This situation it is possible to pull 340 kg in parallel direction to the mounting surface of
the KL300 MultiWinch, as shown in the picture below. Option 1 is preferred over this situation.
4.
Two drums, both fitted with one belt. In this situation it is possible to pull 170 kg with each belt in parallel direction
to the mounting surface of the KL300 MultiWinch, as shown in the picture on the next page.
+90°
-90°
+90°
-90°
14
