Assembly; Assembling The Cutting Attachment Guard; Assembling The Cutting Attachment - Efco D - BC Manual De Instrucciones

Assembling the cutting attachment guard

(Fig. 5B)
- Insert the two pins (E) of the cutting
attachment guard, in the holes (F).
- Assemble the guard (A) to the gearbox with
screws (B) and washers (G) in a position
allowing the operator to work safely.
WARNING:
cutting attachment without an
approved guard. See the section
on Recommended
attachments (Page 9). An incorrect
or faulty guard may lead to serious
personal injury.
WARNING: The deflector provided
with your brush cutter may not
protect the operator from all
foreign objects (gravel, glass, wire,
etc) thrown by the rotating cutting
attachment.
may also ricochet and strike the
operator.
WARNING: Immediately replace a
broken or damaged guard; never
try to mount the guard in incorrect
position.

Assembling the cutting attachment

WARNING:
cutting attachment it is extremely
important that the drive flange
engages correctly in the centre
hole of the cutting attachment. If
the cutting attachment is fitted
incorrectly it can result in serious
and/or fatal personal injury.

ASSEMBLY

Never use
cutting
Thrown objects
When fitting the
WARNING:
attachments with the guards we
recommend!
on
attachments (Page 9). Refer to
the instructions for the cutting
attachment to check the correct
way to load the cord and the correct
cord diameter. Keep the teeth of
the blade correctly sharpened!
a
Follow
Also refer to the instructions on
the blade packaging. Maintain the
correct blade setting! Follow our
instructions.
WARNING: Always stop the engine
before doing any work on the
cutting attachment. The attachment
continues to rotate even after the
throttle has been released. Ensure
that the cutting attachment has
stopped completely and disconnect
the HT lead from the spark plug
before you start to work on it.
WARNING: Using an incorrect
cutting attachment or an incorrectly
sharpened blade increases the risk
of kickout.
WARNING: Always discard a blade
that is bent, twisted, cracked,
broken or damaged in any other
way. Never attempt to straighten
a twisted blade so that it can be
reused. Only use original blades of
the specified type.
WARNING: To reduce the risk
of serious injury, never use wire
or metal-reinforced line or other
material in place of the nylon
cutting lines. Pieces of wire could
break off and be thrown at high
speed toward the operator or
bystanders.
Only use
See the
Recommended
our recommendations.
cutting
chapter
cutting en
11