Idiomas disponibles
Idiomas disponibles
30
18
IMPORTANT: The position of the seat belt/lap strap buckle can affect the
stability of the child car seat. In an accident this could stop the child car seat
from protecting your child as well as it should. If, when the seat belt/lap strap
belt is properly tightened, the buckle lies in the position marked X then try fitting
the child car seat in another seating position in your car.
A
EN
B
D
GENERAL HARNESS ADJUSTMENT
19
It is recommended to adjust the
harness length to fit your child,
before installing the child car seat
into the car.
To tighten the shoulder straps, pull
the webbing at the end of the TMS
system (A) until achieving the fit and
tension required.
To loosen off the shoulder straps
push inwards the TMS release catch
(B) and pull forward the shoulder
straps (C) with the other hand
keeping the TMS catch pushed
down. Releasing the catch will
secure the harness in place.
NOTE: The harness must be
reasonably
tight.
It
restrain but not make the child
uncomfortable.
Check that the straps are not twisted
while the child is seated.
B
A
C
should
FASTENING HARNESS BUCKLE
20
Fit the two shoulder strap buckle parts together (A) and push into the crotch
fitting (B) until a firm click is heard. To open press the RED button (C).
C
A
ADJUSTING THE SHOULDER STRAP POSITION
21
The shoulder straps must be
threaded through the slots in
the front cover and shell nearest
the top of the child shoulders. If
in any doubt always use the slot
above the shoulder rather than
below it.
Press the button on the harness
buckle and release the shoulder
straps. Remove the chest pads
from the shoulder straps.
Push the shoulder straps and
harness clips through the slots
in the seat back and fabric cover
(A). Push the shoulder straps and
harness clips back through the
slots in the seat back and fabric
cover (B). Re-fit the chest pads to
the shoulder straps.
B
C
A
B
31
EN
