Idiomas disponibles
Idiomas disponibles
9.
Operation
9.1.
Turn ON the camera
Put the switch in the ON position; the camera is ready to work.
The red start-up indicator light located on the front cover will blink and the LCD
display will count down 5 seconds. This interval allows you time to close the camera
front cover and leave the monitored area.
Once in the ON mode, the camera will take photos and/or videos according to its
current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings.
9.2.
Turn OFF the camera
Slide the switch to the OFF position to turn off the camera.
Please note that even in OFF mode, the camera still consumes power at a very low
level. Therefore, please remove the batteries if the camera will not be used for a long
time period.
The OFF mode is the "safe mode" for actions such as: replacing the memory card or
batteries, or transporting the camera.
9.3.
Customizing the operating settings
To enter the camera settings MENU, slide the switch to the SETUP position (the LCD
screen will light up), then press the MENU button.
You can navigate the setting interface by pressing , , or . Press OK for
selection, press MENU to exit to the previous page, and press MENU to switch
alpha/digits/symbols.
The settings presented below can be made directly on the LCD screen of the device
but also in the free mobile application available on Android and iOS.
GENERAL MENU (displayed by default)
Mode
PIR interval
Time Lapse setting
00:20
OFF
Guide PIE1061 – Juillet 2023 – ind. A - 27/112
PIR sensitivity
IR LED brightness
Timer
OFF
